We list only what we actually cut.
Material is sourced per order to the grade your drawing calls for, and checked on arrival before machining starts. If a specified grade is hard to source or drives cost without adding function, we will say so before quoting — never substitute silently.
| Material | Notes | Typical parts |
|---|---|---|
| Aluminum | Lightweight, corrosion-resistant | Brackets, housings, plates, heat-spreading parts |
| Stainless Steel | Corrosion-resistant grades for wet environments | Shafts, fittings, fluid-contact parts |
| Brass | Free-cutting, clean finish | Fittings, connectors, decorative hardware |
| Copper | High conductivity | Electrical contacts, bus parts, terminals |
| Steel | Incl. carbon steels | Structural parts, tooling, shafts |
| Iron | Cast / machined to drawing | Bases, housings |
| Alloy & Zinc | To drawing | Die-cast + machined finishing, hardware |
| Engineering Plastics | Lightweight, insulating | Insulators, wear parts, guides |
Not sure which grade fits? Send the drawing and the working conditions — we will flag cheaper equivalents where they are safe.